Make the mechanical parts

The purpose of this mechanical parts is shows how this DICM system moves on the rod of iron. This mechanical parts have been made in Sekyen 17, Shah Alam. Picture below shows the process to make the mechanical parts. 

The workshop map:

Design of mechanical parts:

Making mechanical parts process: 

~ Measuring

~ Cutting

~ Drilling 

~ Soldering 

~ Complete mechanical parts

By doing this mechanical parts, the DICM system is ready to testing on this iron. 

Assemble DICM circuit in the boxes

This procedure is important to protect the circuit from damage. Besides that, it will protect all the electronic components and wire's from heat and water and in addition, it will be used to placing the DC gear motor on the top and placing the water sprinkler tank at the side of boxes.  The assembling DICM circuit in the boxes process are shown in picture below:

DICM system (front view) 

* Tools and equipment used:

~ Screw driver

~ Test pen

~ Long nose

~ Soldering iron 

~ screw (set)

Assemble the components

Below are the some of components used for this DICM system:
~ Solenoid motor 12V
~ DC gear motor 12V
~ DC motor for water sprinkler 12V
~ Liquid Crystal Display (LCD)
~ IR sensor
~ Buzzer 
~ IC driver motor
~ Power transistor 
~ Crystal
~ Resistor
~ Capacitor
~ Diode
~ etc 

Picture below show the components that used in this DICM system: